How to Install Scott Living Paintable Wallpaper
Installing Scott Living paintable wallpaper can transform any room into a stunning space that reflects your personal style. Whether you’re updating a bedroom, bathroom, or kitchen, the right wallpaper can make a significant impact. This guide will walk you through the steps to install Scott Living paintable wallpaper like a pro, ensuring a smooth and beautiful finish.
1. Prepare the Surface
Before you begin installing the wallpaper, it’s crucial to prepare the surface. Make sure the walls are clean, dry, and smooth. Remove any old wallpaper, paint, or debris. Fill in any holes or cracks with spackling compound and sand the surface until it’s smooth. Allow the surface to dry completely before proceeding.
2. Measure and Cut the Wallpaper
Measure the height and width of the room or the specific wall where you plan to install the wallpaper. Add a few inches to each measurement to account for any trimming. Unroll the wallpaper and measure the length of the wallpaper roll. Cut the wallpaper to the desired length using a sharp utility knife or scissors.
3. Apply Adhesive to the Wall
Mix the wallpaper adhesive according to the manufacturer’s instructions. Apply the adhesive to the wall using a roller or brush, ensuring it covers the entire surface. Allow the adhesive to dry for the recommended time, typically 10-15 minutes, before hanging the wallpaper.
4. Position the Wallpaper
Start by positioning the top edge of the wallpaper at the ceiling. Use a level to ensure it’s straight. Smooth out any air bubbles or wrinkles using a wallpaper brush or the back of a刮刀. Continue working from the top down, ensuring the wallpaper is aligned and tight against the ceiling and corners.
5. Trim the Edges
Once the wallpaper is in place, use a straight edge and a utility knife to trim the excess wallpaper from the ceiling, corners, and floor. Be careful not to cut the wallpaper itself while trimming. Smooth out any rough edges with sandpaper if necessary.
6. Apply Adhesive to the Wallpaper
After trimming the edges, apply adhesive to the back of the wallpaper. This step is essential for ensuring a secure and long-lasting installation. Follow the manufacturer’s instructions for the correct amount of adhesive and allow it to dry for the recommended time.
7. Hang the Wallpaper
Now it’s time to hang the wallpaper. Starting from the top edge, unfold the wallpaper and smooth it onto the wall using a wallpaper brush or the back of a刮刀. Continue working from the top down, smoothing out any air bubbles or wrinkles as you go. Be sure to align the pattern or design if applicable.
8. Allow the Wallpaper to Dry
Once the wallpaper is in place, allow it to dry completely. This process may take several hours or even overnight, depending on the adhesive and environmental conditions. Avoid walking on the wallpaper or exposing it to moisture during this time.
9. Touch Up and Finishing Touches
After the wallpaper has dried, inspect the installation for any imperfections. Use a putty knife or a razor blade to carefully remove any air bubbles or small wrinkles. Touch up any minor cuts or scuffs with a matching paint or wallpaper repair kit.
Congratulations! You’ve successfully installed Scott Living paintable wallpaper. Enjoy your beautiful new space and the satisfaction of a job well done.
